TECHNICAL CENTRE / OPERATION AND REPAIRS

Composite repair starts with the cause, not a patch.

Leaks or cracks can have different causes: pressure surges, chemical attack or a defective joint. We first assess the system and cause, then the options for repair or replacement.

01 / WHAT MATTERS

What we need to know before recommending a solution.

Repair advice without the fluid, loads and pipe identification would be guesswork. That is not how we work.

02 / DECISION FACTORS

Three steps before planning a repair.

01 / SAFETY

Make the situation safe

Follow the operating site’s safety rules first. Take photographs only from a safe location.

02 / IDENTIFICATION

Identify the system and defect

Pipe markings, photographs, fluid, damage location and time in service.

03 / PROCEDURE

Assess the intervention options

We assess whether to repair or replace the component and whether further inspection is needed. The procedure must match the system and site safety requirements.

03 / BEFORE CONSULTATION

What to send so we can advise effectively.

Photographs, pipe markings, fluid, operating conditions and damage location. If markings are missing, provide at least the diameter and known information.

Send photographs of the damage, pipe identification and fluid. First the cause, then the procedure.

INCLUDE A DESCRIPTION OF THE DEFECT AND AVAILABLE SYSTEM INFORMATION.

DISCUSS YOUR PROJECT ↗